PRODUCT DESCRIPTION
The
xMove Deluxe
charger is an automatic charger, developed to charge NiCd / NiMH batteries packs from 1 to 14 cells (1.2-16.8V DC), LiIon
/ LiPo batteries from 1 to 5 cells (3.6-18.5V DC) or Lead Acid batteries from 1 to 6 cells (2.0-12.0V DC). Due to its DC input on the primary side
this charge can be used connected to a car battery or another 11-15V DC high current supply and is independent from a mains power supply system.
The Micro controller inside the
xMove Deluxe
charger will ensure that all set modes; charge / discharge / cycle are controlled in a very precise way.
The charge cut off for NiCd / NiMH battery packs is made with the ”Minus Delta Peak” system. An additional safety timer where the time is
automatically calculated due to the set battery capacity adjusted by the user is running in the background. A defined pre-charge, 3 minutes with 1C,
will make sure that the battery pack is recognized and charged correctly. After the fast charge cut-off a trickle charge current will compensate for
the self discharge of the battery.
LiIon / LiPo and Lead Acid batteries are charged with the CCCV charge characteristic (Constant Current / Constant Voltage). First the batteries will be
charged with a high constant current until the end charge voltage is reached. Afterwards the charge process changes to constant voltage. The charge
current is reducing during this mode. When the charge current is lower than a pre-defined charge current the charger will switch off. This prevents any
damage to the battery. A safety timer is working in the background.
For NiCd and NiMH battery packs a Cycle mode is available. In the first mode, to refresh batteries, the charger starts with a defined discharge and
recharges afterwards until cut off. To define the battery capacity and get a statement about the quality of the battery, the charger will start and
charge the battery first. Thereafter a discharge process will start. At the end the display will show the capacity in mAh which was inside the battery.
The charge current has a continuous adjustment from 0.1 to 5.0 A. As an option the batteries can be discharged with an adjustable current from 0.1
to 1.0 A. All procedures will be shown on a display with 2 lines and 16 digits. The input as well as the output circuit have a protection against wrong
polarity. The output circuit is also short circuit protected.
5
1_manual_xmove_06-12.indd 6
1_manual_xmove_06-12.indd 6
11.01.2007 16:45:38 Uhr
11.01.2007 16:45:38 Uhr
Prozessfarbe Schwarz
Prozessfarbe Schwarz