ANSMANN Racing xMove Deluxe Operating Instructions Manual Download Page 10

Page: 10 / 40

LiION-BATTERIES, LiIo CHARGE

Push the button “BATT TYPE” until the display shows “LiIo”. Now use the “INC” or “DEC” button to get to “CHARGE” and then push “ENTER”
to confirm. After your confirmation the display will change to the capacity “C”. Now please set the capacity of your battery with the buttons
“INC” or “DEC” from 100 mAh to 5000 mAh and confirm with “ENTER”. The charge current is automatically set to 1C. The display changes to
the no. of cells / cell voltage which can be set with the “INC” or “DEC” buttons from 1 cell = 3.6Vp; 2 cells = 7.2Vp; 3 cells = 10.8Vp; 4 cells =
14.4Vp to 5 cells = 18.0Vp. The parameters shown on the display are set and stop flashing if no push button is pressed for 3 seconds. To start
charging, now push the “ENTER / START / STOP” button for 2 seconds. The display shows “BATTERY CHECK WAIT PLEASE“. After a short check of
all parameters the display shows the battery type “LI”, the charge mode “CHG”, the charge current e.g.: “+3.00A” (if the battery capacity is set
to 3000mAh) and the actual measured battery voltage “V”. The clock starts running in seconds and the display shows also the charged capacity.
When the charging is finished you will get an audible signal. The display shows the capacity charged into the battery.

LiIo DISCHARGE

Push the button “BATT TYPE” until the display shows “LiIo”. Now use the “INC” or “DEC” button to get to “DISCHARGE” and then push “ENTER”
to confirm. After your confirmation the display will change to the discharge current “D”. Now please set the discharge current with the buttons
“INC” or “DEC” from 0.10 A to 1.00 A and confirm with “ENTER”. The display changes to the no. of cells / cell voltage which can be set with
the “INC” or “DEC” buttons from 1 cell = 3.6Vp; 2 cells = 7.2Vp; 3 cells = 10.8Vp; 4 cells = 14.4Vp to 5 cells = 18.0Vp. The parameters shown
on the display are set and stop flashing if no push button is pressed for 3 seconds. To start discharging, now push the “ENTER / START / STOP”
button for 2 seconds. The display shows “BATTERY CHECK WAIT PLEASE“. After a short check of all parameters the display shows the battery
type “LI”, the charge mode “DIS”, the discharge current e.g.: “-1.00A” and the actual measured battery voltage “V”. The clock starts running in
seconds and the display shows also the discharged capacity. The batteries will be discharged to a preset discharge voltage of 2.7V± 10% / cell.
When the discharging is finished you will get an audible signal. The display shows the capacity discharged from the battery.

Adjustments and the associated display you can be seen in the following chart:

Liio CHARGE
C=3000mAh 10.8Vp

LiIo CHARGE
C=3000mAh 10.8Vp

Battery check
Wait please...

CHG 0:00 00000
LI + 3.00A 10.75V

Liio DisCHARGE
D=0.50A 10.8Vp

Battery check
Wait please...

CHG 0:00 00000
LI - 0.50A 10.75V

#"555:1&

&/5&3

%&$

*/$