Anritsu Site Master S112, User Manual, Page: 19 / 83

ESCAPE
key is held down, the factory preset state is
restored.
PRINT
Prints the current display to the selected printer.
RECALL
DISPLAY Recalls a previously saved trace from memory loca-
tion 1 through 40. When the key is pressed, “Recall
display:” appears on the display. Select an appropri-
ate number from the keypad and press the
ENTER
key to implement.
RECALL
SETUP Recalls a previously saved setup from memory loca-
tion 0 through 9. When the key is pressed, “Recall
Setup:” appears on the display. Select an appropriate
number from the keypad and press the
ENTER
key
to implement. Setup 0 recalls the factory preset state.
RUN
HOLD
When in the Hold mode, this key starts the Site Mas-
ter sweeping and provides a Single Sweep Mode
trigger; when in the Run mode, it pauses the sweep.
When in the Hold mode, the hold symbol (Table 2-1,
page 2-45) appears on the left side of the LCD.
(HOLD conserves considerable battery power.)
SAVE
DISPLAY Saves the displayed trace to 1 of 40 internal non-
volatile memory locations. When the key is pressed,
“Save display:” appears on the display. Select an ap-
propriate number from the keypad and press the
ENTER
key to implement.
CAUTION:The selected memory location will be over-
written by the SAVE DISPLAY operation. No warning
is given.
2 - 3
Chapter 2 Operation