4
Fluorescent lamp
X 2
X 1.5
40W Lamp
80VA (W)
60 VA (W)
Appliances with motor
X 3-5
X 2
Refrigerator 150W
450-750VA
(W)
300 VA (W)
3.2. START-UP, OPERATION AND SHUTDOWN OF THE GENERATOR SET
START-UP OF THE ELECTROGEN GROUP
- Check the oil and gasoline levels.
- Put the fuel cock in the “OPEN” position.
- Put the choke lever in the “CLOSED” position
- Put the motor contact in the “ON / I” position
MANUAL START
- Pull the starter grip slightly until you feel it resisting, then pull with a sharp
blow.
WARNING: Do not allow the starter handle to return abruptly to its position,
but you must accompany it with your hand slowly to avoid
damage the launcher.
ELECTRIC START -Optional-
- Turn the starter key (1) to the "START" position and keep it in this position until the engine
starts.
WARNING:
If the engine does not start after 5 seconds, stop the attempt and wait 10
seconds before trying again. - Once the engine is running, turn the ignition key back
to the "ON" position.
NOTE: OIL WARNING SYSTEM: Flashing of the start / stop switch while the engine is starting
indicates a low oil level. The engine will not start or stall without restarting until the oil reservoir
is refilled (the engine contact will remain in the ON "open position).
OPERATION OF THE ELECTROGEN GROUP
When the engine temperature begins to rise, return the choke lever to the
Position “CLOSED” gradually.
- Once the engine speed has stabilized (3 minutes), connect the socket (s)
of them is on. From that moment on, you can use your electrical appliances.
During engine operation, check:
1- if vibrations or abnormal noises occur;
2- if it backfires or the engine runs with difficulty;
3- the color of the exhaust gases (if they are black or too white).
If one of the points mentioned above is observed, stop running the
