Anita GARUDAN GF-1107-147 MH, Manual

Page: 29 / 73

ANITA ©
MP02300EN_220518 GF-1107-147 MH 29
E.10 Adjusting the presser foot pressure and stroke height
Warning: To prevent an accident, turn off the power before starting work.
A. As shown in Figure 35, remove the
rubber cover (2) from the front cover (1).
Then lower the foot (3) onto the stitch
plate. Loosen the screw (4) and set the
required height. The height of the foot
increases with the stroke of the pressure
rod holder. Manually lift the foot with the
lever (5) to set the 5.5 mm distance
between the lower edge of the foot and the
upper edge of the stitch plate.
B. By turning the screw (6) clockwise, the
presser foot pressure increases, and
conversely,
by turning the screw
counterclockwise, the presser foot pressure
decreases. After adjustment, tighten the nut
(1) according to Fig. 35
C. Loosen the screw (1) and adjust the
height or angle of the foot. After
adjustment, retighten the screw carefully
(Fig. No. 36)