Anilam 5000M, Installation Manual

Page: 15 / 18

5000M Crusader G Upgrade Installation Guide
P/N 70000549B
All rights reserved. Subject to change without notice. 15
14-February-03
Setup Utility Navigation
NOTE: If you purchased your Handy Pulser separately from the CNC,
you must configure Setup Utility parameters before operating
the Handy Pulser. If you purchased your Handy Pulser with the
CNC,
Setup Utility parameters are already configured, and you
only need to mount the Handy Pulser.
The Setup Utility provides access to all CNC settings through a layered
organization of menus. Each menu contains a list and provides access to
configuration settings or another menu. To select a listed choice,
highlight the selection. Press
ENTER
to activate the highlighted selection.
For some settings, press
ENTER
to toggle the setting On or Off . Other
settings require you to enter a specific value. To automatically save a
highlighted setting, press
ENTER
or press Exit ( F10 ). To return to a
previous menu, close the current menu by pressing F10 .
Handy Pulser Setup
NOTE: Some steps in these procedures may require you to enter a
service-level password. Refer to 5000M CNC Setup Utility
Manual , P/N 70000509, “Password Restricted Parameters.”
To configure the handwheel in the Handy Pulser:
1. Refer to
Figure 6, 5000M Handy Pulser Setup Menus . In Manual
Mode or Power-Up Mode, press
EXIT
( F10 ) to display the Software
Options Menu .
2. In the Software Options Menu , highlight Setup Utility , and press
ENTER
. The Setup Options Menu, Menu A , is displayed.
3. Highlight Builder Setup , and press
ENTER
.
4. In the Builder Setup Menu , highlight Handwheel/DRO , and press
ENTER
. The Handwheel/DRO Setup Menu, Menu C , is displayed.
5. Highlight Handwheel/DRO #1 , and press
ENTER
. The Handwheel
DRO #1 Setup Menu, Menu D , is displayed.
6. Verify that Type is set to Handwheel . If necessary, press
ENTER
to
display the Options popup menu, and select Handwheel .
7. Highlight Handwheel in the Handwheel DRO #1 Setup Menu , and
press
ENTER
. The Handwheel Setup Menu, Menu E , is displayed.
8. Highlight Scaling Factor , and press
ENTER
.
9. Type the Scaling Factor (usually 1.00), and press
ENTER
.
10. Press EXIT ( F10 ) successively until the Save Changes? prompt is
displayed in the middle of the screen.
11. Select Yes ( F1 ) to save the changes.
The handwheel is now ready for use.