ANGELTRAX
MINI
MICRO MOBILE DIGITAL VIDEO RECORDER
Record
Data Download
Power
A/V
Output
Remote Access
Record indicator light
flickers in REC mode
{ Panic Button }
5
MINI
MICRO PLUS
ANGELTRAX
MINI
MICRO
PLUS DIGITAL VIDEO RECORDER
6
A/V Output on MDVR
A/V Opening on Door
A/V
Output
ANGELTRAX
MINI
MICRO MOBILE DIGITAL VIDEO RECORDER
Remote Access
Record
Power
Data Download
7
MENU
POP
AUDIO
REWIND
PLAY
PAUSE
STOP
QUAD
ZOOM SEQUENCE
COPY
ENTER
8
AngelTrax
| 10
6. Ensure the MiniMicro Plus powers-up and goes into REC
(Record) mode, indicated by the flickering amber light on
the front of the unit and — if connected — on the panic
event button (see Figure 5). If the unit fails to go into REC
mode, make sure the hard drive is in the ‘lock’ position.
7. Power-down the unit by turning off the ignition and
disconnect the power cables.
8. Connect all signal and camera cables to the back of the unit
and reconnect the power cables to the unit.
9. When everything is working properly, attach the back cover
around the cables and onto the back of the unit (see
Figure 6).
10. Power-up the MiniMIcro Plus by turning on the
vehicle’s ignition.
11. Connect the local monitor to the MiniMicro Plus, either
without the front cover, or through the A/V output opening in
the front cover (see Figure 7).
12. Check camera angles, signal inputs and test audio.
13. Remove the plastic insert in the battery compartment of
the supplied DVR remote. Select Menu located in the top
left corner of the remote (see Figure 8), to set the correct
time (Refer to the Date/Time Setup Section, page 20, for
detailed instructions).
14. Turn the vehicle ignition off and confirm the shut down
delay is working properly.
CAUTION - POWER CONNECTION:
Ensure the connection to the power source is secure,
and then connect the cables to the rear of the DVR.
