C1
39
60
36
00
.fm
- 11 -
IT
AUS
DE
FR
ES
To carry out this operation, proceed as follows.
1- Switch the appliance off and leave it to cool (see
page7
2 - Turn off the circuit-breaker to disconnect it from
the electrical mains.
3 - Remove the basket support structure (
A
).
4 - Drain and filter the oil (see page8).
5 - Apply a food-grade detergent to the inside of the
well.
6 - Rinse the well with drinking water and drain.
7 - Apply a specific product or a water and vinegar
solution to the well to remove the detergent resi-
dues.
8 - Rinse, empty and dry the well.
To carry out this operation, proceed as follows.
1- Turn off the gas supply tap.
2 - Open the hatch (
A
).
3 - Undo the pressure connection screw (
B
).
4 - Connect the pressure gauge (
C
) to the pressure
test point.
5 - Turn the gas supply tap back on.
6 - Use the knob (
D
) to light the burner (see page7).
7 - Perform a cooking cycle without food at the maxi-
mum temperature (see page8) then check that the
pressure reading complies with the values provid-
ed in the table at the back of the manual.
8 - Turn off the burner, disconnect the pressure
gauge and restore the initial conditions after com-
pleting the operation.
The appliance has been tested before being put into
service. The information provided below is intended
to assist in the identification and correction of any
anomalies and malfunctions which might occur dur-
ing use. The user can solve some of these problems
himself, but for others specific technical knowledge or
skill is required, and so they must only be carried out
by qualified staff with recognised experience ac-
quired in the specific sector of operation.
CLEANING THE WELL
CHECKING GAS PRESSURE
FAULT
6
TROUBLESHOOTING
A
IDM-39603311300.tif
A
C
B
D
IDM-39603615700.tif
