7
INSTALLATION
4 Separate the alarm from the mounting
plate This may require you to turn the
alarm clockwise while holding the base
plate
WARNING: do not screw the base plate
of the alarm to it’s mounting surface
with the alarm fitted to it Dust from the
fitting process could contaminate this
very sensitive device
5 Locate the base plate in your chosen
position and mark the position of the
mounting holes Drill the holes using
a 4 75 mm drill Insert the anchor plugs
and screw the base plate to the chosen
position DO NOT OVER-TIGHTEN THE
SCREWS this will distort the base
plate
Test button
Sounder
Alarm base
mounting hole
Operating light
Alarm base
mounting hole
6
Fitting / Replacing the batteries:
a Undo the screw and remove the
battery access door from the back of
the alarm
When alarm is located on base unit,
twist in this direction to lock
Line up arrows
and insert
alarms into
base
Battery
cover
Fit two new AAA (LR03) batteries
(supplied with a new alarm) in the
battery bay making sure they are
fitted the correct way round by
referring to the diagram on the back
of the alarm Allow ten seconds
before testing the alarm
WARNING: USE ONLY DURACELL
MN2400 OR GP 24AU BATTERIES
OR ENERGIZER LROJ, OTHER
BATTERIES MAY BE INADEQUATE
b Refit the battery access door
7
Line up the arrow on the back of the
alarm with the arrow inside the base
plate and inset the alarm Once the
alarm is inside the base plate twist it
anti-clockwise to lock it into place
8
Test the alarm
ALARM TEST
1
Press and release the test button to
test alarm The alarm should sound
three times
2 After testing check that the red light
flashes approximately every 40
seconds
3 Test the alarm once a week to ensure
correct operation
Storage in low humidity, and certain
transportation conditions may cause
electrostatic charges to build up in the
alarm system housing Although harmless,
they may increase the length of time that
the horn sounds upon battery insertion or
test button operation The condition may
be cleaned by gently wiping the outside of
the plastic cover with a clean, damp cloth
Summary of Contents for SA700-AE-UK
Page 12: ......
