Anemoment LLC
16
Data Logger 422 User Manual
Note
that connectors must be mated and the cable of the mating connector sealed to achieve the
IP67 rating.
DL422-E-Series to GPS or Radio (3.3V UART Serial)
The DL422-B is packaged with one
Figure 6. This cable connects the DL422-B to an appropriately
rated off-the-shelf serial instrument, such as a GPS receiver or
properly licensed and certified radio transceiver.
At the other end is a JST GHR-06V-S snap connector that must be
snapped into the desired instrument header on the circuit board,
as shown in Figure 7.
Be careful to snap the connector into the correct header for the
intended purpose.
Instrument headers and other parts of the
circuit board geography are described in Chapter 7
Board Geography and Pin Assignments
, below.
5
Additional 6-Socket Serial Input Cables may be purchased from Anemoment. Information about the
connectors and wire positions is provided to guide skilled electronic technicians in making custom-built cables.
Anemoment is not responsible for the function of custom-built cables.
Figure 6: 6-Socket 3.3V UART Serial
Input Cable
Figure 7: JST Snap Connector in Place
