DN:KD-927-SMSY01 V2.0 Operation Guide
10/22
c. The cuff should be placed at the same level as your heart.
6. TAKING YOUR BLOOD PRESSURE READING AND
BLUETOOTH
a. In Standby Mode, you can only activate the device by pressing “START/STOP”
button and the LCD full display .You can check the LCD display according to the
picture 6-1. Please contact the service center if segment is missing. In case of
empty battery you will wait for 1 minute or press the “START/STOP” button to go
back to standby mode .
b. After the LCD full display, the device display the clock and date, See picture6-2,
you can press the “START/STOP” button to go to the test mode, or you can
press the button “M1” or “M2“ to go to the memory mode.If you press “M1”
button,you will scan user 1 memory, If you press “M2” button,you will scan user 2
memory.
c. If you no press any button,the device will go to the test mode automatically after
3 seconds.
Picture 6-1 Picture 6-2
d. After applying the cuff and your body is in a comfortable position , you can enter
the test Mode and the LCD display 0 mmHg, See picture6-3
；
e. Then the monitor inflates the cuff until sufficient pressure has built up for a
measurement. Then the monitor slowly releases air from the cuff and carries out
the measurement. .Finally the blood pressure and pulse rate will be calculated
and displayed on the LCD. See picture 6-4. The irregular heartbeat symbol (if any)
and blood pressure classification indicator will blink on the LCD. Display HSD
positive/negative symbol .