DN:KD-5985-SMSY01 V3.0 Operation Guide
Template version:1
6/22
14.
The monitor might not meet its performance specifications or cause safety hazard if
stored or used outside the specified temperature and humidity ranges in specifications.
15.
Please do not share the cuff with other infective person to avoid cross-infection.
16. The AC adapter which output is DC 6.0V, 800mA and complied with IEC 60601-1/EN
60601-1/UL 60601-1 and IEC 60601-1-2/EN 60601-1-2/UL 60601-1-2 is suitable for this
monitor, we suggest use ASP5-06008002EU (input: 100-240V, 50/60Hz, 200mA; output:
DC 6V, 800mA) or ASP5-
06008003UK
(input: 100-240V, 50/60Hz, 200mA; output: DC
6V, 800mA) which are complied with IEC 60601-1/EN 60601-1/UL 60601-1 and IEC
60601-1-2/EN 60601-1-2/UL 60601-1-2, if use the monitor with AC adapter in USA, use
only ASP5-06008002JU(input: 100-240V, 50/60Hz, 200mA; output: DC 6V, 800mA) which
is complied with IEC 60601-1/EN 60601-1/UL 60601-1 and IEC 60601-1-2/EN
60601-1-2/UL 60601-1-2. Other adapters not approved for use with the monitor may
damage it. Please note that the monitor jack size: hole Φ5.5mm, center pin Φ2.0mm.
Please pay attention to polarity.
17. This blood pressure monitor is verified by auscultatory method. It is recommended that
you check annex B of ANSI/AAMI SP-10:2002+A1:2003+A2:2006 for details of verification
method if you need.
18. This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
SETUP AND OPERATING PROCEDURES
1. BATTERY LOADING AND AC ADAPTER
LOADING
a. Open battery cover at the back of the monitor.
b.
Load four ―AA‖ size batteries. Please pay attention to
polarity.
c. Close the battery cover.
