DN:KD-5985-SMSY01 V3.0 Operation Guide
Template version:1
10/22
Avoid compression or restriction of the connection tubing during measurement
，
which
may cause inflation error, or harmful injury due to continuous cuff pressure
.
4. APPLYING THE CUFF
a. Pulling the cuff end through the medal loop (the cuff is packaged like this already),
turn it outward (away from your body) and tighten it and close the Velcro fastener.
b. Place the cuff around a bare arm 1-2cm above the elbow joint.
c. While seated, place palm upside in front of you on a flat surface
such as a desk or table. Position the air tube in the middle of your
arm in line with your middle finger.
d. The cuff should fit comfortably, yet snugly around your arm.
You should be able to insert one finger between your arm and
the cuff.
Note:
Please
refer
to
the
cuff
circumference
range
in
―SPECIFICATIONS‖ to make sure that the appropriate cuff is used.
Measuring on same arm each time.
Do not move your arm, body, or the monitor and do not move the rubber tube during
measurement.
Stay quiet, calm for 5 minutes before blood pressure measurement.
Please keep the cuff clean. If the cuff becomes dirty, remove it from the monitor and
clear it by hand in a mild detergent, then rinse it thoroughly in cold water. Never dry
the cuff in clothes dryer or iron it. Clean the cuff after the usage of every 200 times is
recommended.
5. BODY POSTURE DURING MEASUREMENT
Sitting Comfortably Measurement
a. Be seated with your feet flat on the floor
, and don’t cross your legs.
b. Place palm upside in front of you on a flat surface such as a desk or
table
c.
The middle of the cuff should be at the level of the right atrium of the heart.
Lying Down Measurement
a. Lie on your back.
b. Place your arm straight along your side with your palm upside.
c. The cuff should be placed at the same level as your heart.
6. GROUP SELCET
