8
If local codes permit grounding through the electrical supply neutral, connect
both the white neutral wire and the green ground wire from the oven to the
white neutral electrical supply wire.
•
Check with a qualified electrical installer if you are not sure the oven is
properly grounded.
•
Single Oven
- When a 4-wire, single phase 120/240 volt, 60 Hz., AC only
electrical supply is available, a 25-amp maximum circuit protection is
required (or, if specified on the model/serial rating plate, when a 4-wire,
single phase 120/208 volt 60 Hz., AC only electrical supply is available, a
20-amp maximum circuit protection is required).
•
Double Oven
- When a 4-wire, single phase 120/240 volt, 60 Hz., AC only
electrical supply is available, a 40-amp maximum circuit protection is
required (or, if specified on the model/serial rating plate, when a 4-wire,
single phase 120/208 volt 60 Hz., AC only electrical supply is available, a
35-amp maximum circuit protection is required).
IMPORTANT:
This appliance shall be installed only by authorized persons
and in accordance with the manufacturer’s installation instructions, local
gas fitting regulations, municipal building codes, electrical wiring
regulations, local water supply regulations.
STEP 1 - UNPACK THE OVEN
1.
Using two or more people, remove the oven and set it on cardboard to
avoid floor damage.
NOTE:
Do not use the handle or any portion of the front frame for lifting.
2.
Remove the shipping materials and tape from the oven.
3.
Remove the hardware package from inside the bag containing literature.
4.
Remove and set aside racks and other parts from inside the oven.
5.
Move the oven on the cardboard near where it will be installed.
Installation Requirements
Installation Instructions
Excessive Weight Hazard
WARNING
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.