XFR Apprentice Workout Station
Assembly Instructions
Prep for mounting on wall
PLEASE NOTE:
The support boards are 31” wide in order to accommodate studs that are
16” or 24” from center, or for unusual spacing.
Use the 5/8” x 4” lag screws (included) to mount these boards
Step 1
Use a stud finder to locate the studs in your wall where you want to mount your station.
Once studs are located, measure the distance between the two studs.
Step 2
From the center of each support board, measure half of the distance between your
studs. For example, if your studs are 31” apart, use 15 1/2”.
Mark these distances as this is where you will pre-drill holes for mounting.
Step 3
Pre-drill holes in each support board.
We recommend drilling holes slightly smaller than the 5/8” lag screws.
The XFR Workout Station is now ready to be assembled.
