Anatomic SITT Zitzi Seabass Pro, User Manual, Page: 28 / 56

28 User manual Zitzi Seabass Pro www.anatomicsitt.com | +46 11 16 18 00
Installation of drum brake
You need to remove the wheel from the wheelchair to mount the drum brake. Press
the button on the quick-realease axle and pull the wheel and axle out from the
drum brake.
Mount the drum brake on the chassis by putting a large spacer (D) over the drum
brakes threaded axle and push it in the intended hole for the desired position.
Attach the big nut (H) to the inside of frame side plate and tighten something. It is
important to not tighten too hard.
Stick the screw (C) through the hole for rotation lock in the brake drum (A),
through the small spacer (E) and through the holes in the frame side.
See pages 22-23 with frame pictures for possible locations of driving wheels and
drum brakes.
Attach with washer (F) and nut (G) on the inside of the frame side plate.
Tighten both nuts (H) and (G) so that the brake drum is securely tightened.
The brake drum’s rotation stop should point diagonally backwards/upwards for
12/16 ”and diagonally forward/upwards for 20-24”.
Take the quick-release axle with the wheel and push until the wheel attaches. Test
by pulling the wheel slightly outwards (without pressing the quick release button).
Brakes
Note! The brake drum’s rotation stop should point diagonally
backwards/upwards for 12/16 ”and diagonally forward/upwards
for 20-24”.
Note! For more information about using quick-release, see
page 20-21.
Note!
The mounting principle of drum brake is the same regardless of
wheel size.