QUICK START GUIDE – DIGI SCAN 1600
ANALOG WAY
EDITION : 06/07
CONNECTIONS:
c
Turn OFF all of your equipment before connecting.
d
Connect the AC power supply cord to the DIGI SCAN 1600 and to an AC power outlet.
e
Connect your computer source to the COMPUTER INPUT (HD15) connector or the DVI-D INPUT connector.
f
As required, connect a control monitor on the MONITOR OUT (HD15) connector.
NOTE
: Set the RGB Hi-Z/75
Ω
button on Hi-Z if you connect a monitor on the MONITOR OUT connector. If not set
it on 75
Ω
.
NOTE:
The MONITOR OUT is available only if the COMPUTER source is analog.
g
Connect your display devices (TV monitor, VCR...) to the outputs (analog or SDI).
h
Turn ON the DIGI SCAN 1600 (rear panel switch). Then turn ON your input source and then your display devices.
•
DIGI SCAN 1600 connection diagram:
2
6
Ω
3
4
5
5
•
RGB/COMPONENT output connection:
SETTINGS:
c
We recommend resetting the DIGI SCAN 1600 to all of its default values, with the front panel display
menu (
Control >
default value > yes
) before proceeding.
d
Select the Input source (ANALOG or DVI) with the front panel display
menu (
Input > Input select.
).
e
Select the Output standard with the front panel display
menu (
Output > output std
).
f
Select the Output rate mode (internal or genlock) with the front panel display menu (
Output > output rate
).
g
Select the type of the
RGB/YUV output
with the front panel display menu (
Output > RGB/YUV out
).
h
As required, make the following adjustments:
-Select the UNDERSCAN mode with the front panel display menu (
Image > under/over
).
-Adjust the image position & size with the front panel buttons.
-Adjust the level of anti-flicker with the panel display menu (
Image > flicker filter
).
-Make the others adjustments, available in the Image menu.
