In the
Protected
Setup
page:
1.
Select
Wireless Settings
.
2.
Locate the Wireless Security section (FIG. 32).
3.
Press the
Static WEP
button to open the Static WEP Settings dialog (FIG. 33).
4.
Press the
SSID
field and from the
Network Name (SSID)
keyboard, enter the SSID name you are
using on your target Wireless Access Point (
case sensitive
), and press
Done
when finished.
The card should be given the SSID used by the target WAP. If this field is left blank, the unit
will attempt to connect to the first available WAP. By default, all WAP200Gs use
AMX
as
their assigned SSID value.
One of the most common problems associated with connection to a WAP arise because the
SSID was not entered properly. You must maintain the same case when entering this
information.
ABC is not the same as Abc
.
The alpha-numeric string is by default
AMX
but can later be changed to any 32-character
entry.
This string must be duplicated within the Network Name (SSID) field on the WAP.
FIG. 32
802.11g wireless card
You must first take down the SSID name, Current Key string value, and panel MAC
Address information so you can later enter it into the appropriate WAP dialog fields in
order to "sync-up" the secure connection. These values must be identically
reproduced on the target WAP.
FIG. 33
Required Information:
- SSID (Network Name used by the Target WAP)
- Encryption Method
- Passphrase
- WEP Key assignment
- Authentication Method
