AMX Endeleo Multi-Format Receiver UDM-RX02, Operation/Reference Manual

Page: 102 / 108

UDM-0102 Control Protocol
88 UDM-0102 and UDM-RX02 Operation/Reference Guide
Get Port or Input Name
Retrieves a string identifier from the port specified. Sub port should be specified if the port type is an Input
port as input sub ports may have different names.
The Port Type parameter can take the following values:
Return status:
Get Receiver Info
Retrieves information about the connected receiver on a port.
Return status:
The Parameter Block contains at least the following - it may contain extra information, but if not defined here
it can be ignored:
Send Remote Command
Sends a command to the Rx (which is normally sent on to the screen or other device connected to the Rx).
Remote command specifies the type of action taken, with optional parameters.
Return status:
All these commands start with the header above (bytes 0-3), but use the remote device command value to
perform separate functions as described below:
Byte # 0 1 2 3 4 5
Byte value 79 User defined Port Sub port Port type User defined
Value Description
1 Output port
2 Video input port
3 Audio input port
4 Device
Byte # 0 1 2 3 4 5 6 7...7+length
Byte value 79 Status Port Sub port Port type User defined Name length Name string
Byte # 0 1 2 3 4 5
Byte value 88 User defined Port User defined User defined User defined
Byte # 0 1 2 3 4...n
Byte value 88 Status Port User defined Parameter block
Byte offset (from 4) Receiver information
0 Receiver type
1 Flags
2 Receiver version number - major
3 Receiver version number - minor
Byte # 0 1 2 3 4 5...n
Byte value 87 User defined Port User defined Remote command Remote parameters
Byte # 0 1 2 3 4 5
Byte value 87 Status Port User defined Remote device command Remote device parameter