AMX Endeleo Multi-Format Receiver UDM-RX02, Operation/Reference Manual

Page: 73 / 108

Configuration - Protocols Page
59 UDM-0102 and UDM-RX02 Operation/Reference Guide
Creating and Learning an IR Protocol
Creating an IR Protocol
1.
Connect the 3.5mm jack of the IR03 External IR Receiver Module to the IR Rx connection on the rear
panel (see FIG. 7 on page 8).
2.
Run the cable and attach the IR Receiver Module within IR range of any remote control devices to be
used.
3.
In the Protocols page, click on the IR Protocol drop-down menu and select New . This invokes the Name
text field (FIG. 73).
4.
Enter a name for the IR protocol in the Name text field.
5.
Click Initialize . This invokes the Action drop-down menu (FIG. 74).
6.
Select an action to be performed from the Action drop-down menu. This invokes the Step 1 option
(FIG. 75).
7.
Click Step 1 to ready the device to receive the IR code (the system prompts you to press the desired key
on the remote control).
8.
Press the corresponding button on the remote.
9.
Click Step 2 on the page to begin the IR code confirmation.
The UDM-0102 can learn approximately 128 IR commands depending on the actual
command length and protocol used.
FIG. 73 Naming the new IR Protocol
FIG. 74 Creating an IR command for the action
FIG. 75 Creating an IR command for the action
Click here to prepare the device to receive the IR code