AMX AVB-DWP-TX-MULTI-DXLINK, Instruction Manual

Page: 119 / 154

Appendix B – Telnet (Terminal) Commands
113 Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Setting a Telnet Username and Password
To set a Telnet username and password:
1.
Establish a terminal connection via Telnet (see page 111).
2.
Type
Set Telnet Username
, and press Enter.
a.
The program will prompt you to enter a new Telnet username; enter a username and press Enter.
b.
The program will indicate that the username is being stored.
3.
Type
Set Telnet Password
, and press Enter.
a.
The program will prompt you to enter a password; press Enter twice to clear both the Telnet
username and password.
b.
Enter a password and press Enter.
c.
The program will prompt you to re-enter the password; re-enter the password and press Enter.
d.
The program will indicate that the password is being stored.
Telnet Commands
The Telnet commands listed in the table below can be sent directly to the Transmitter or Receiver via
a Telnet terminal session.

The default Telnet port is 23 . A value of 0 (zero) disables the Telnet server.

Telnet is enabled by default.
In the terminal program, type
Help
or a question mark (
?
) and press Enter to access the Help Menu and
display the terminal commands described in the table below
.
Telnet Commands
Command Description
? or Help Display the commands listed in this table.
DEVICE STATUS Displays device status of a specified device, port, system (<D:P:S>).
Note: Devices other than the DXLink Transmitter or Receiver itself will be ignored.
Example:
>device status 32002:1:0
Device Status
-------------
Device 32002 AMX LLC,DXLINK-HDMI-RX, 0.0.106.0 contains
7 Ports
Port 1 - Channels:255 Levels:8
MaxStringLen=64 Types=8 bit MaxCommandLen=64 Types=8 bit
The following input channels are on:None
The following output channels are on:None
Level 1=0 Supported data types=UByte,UInt
Level 2=0 Supported data types=UByte,UInt
Level 3=0 Supported data types=UByte,UInt
Level 4=0 Supported data types=UByte,UInt
Level 5=0 Supported data types=UByte,UInt
Level 6=0 Supported data types=UByte,UInt
Level 7=0 Supported data types=UByte,UInt
Level 8=0 Supported data types=UByte,UInt
>