Installing a CP-20A Remote
33
CP-20A Instruction Manual
Applying Power
Power Requirements
+
9 volt DC with at least 500 mA
Important
:
Always use a UL approved power source. Be sure to check the power source
documentation for information specific to that power source.
Power is applied to the CP-20A Remote Panel by connecting to the terminal block connector. If you use
the (optional) AMX AutoPatch wall transformer, the side of the wire with the white stripe is positive and
the other side is the ground. Acceptable power for the controller is +7 to +9 V DC @ 500 mA.
To wire the power connector on the CP-20A Remote:
1.
Unplug the power connector on the CP-20A Remote.
2.
Loosen the two outer screws and insert the power cable wires (FIG. 7).
3.
Tighten both screws and plug the connector back into the remote panel.
4.
Place the CP-20A Remote in a rack or other permanent installation location before applying power.
FIG. 7
Insert the wires and tighten screws
Ground
Positive (+)
Terminal Block Connector
