Documax 5380 User’s Manual
- 39 -
Alignment Adjust Mode
Enter the alignment adjust mode to improve the print quality when the printer is used for a long time.
The steps to adjust the alignment are shown as below:
1. Make sure the tractor paper has loaded and turn on the printer.
2. In the online mode, press and hold on the
LF/FF
key and
ONLINE
key for about 3 seconds, the
printer prints out the current alignment state and enters the alignment adjust mode.
3. After entering the alignment adjust mode, press
the following keys to adjust the degree of make
columns:
EJECT/LOAD:
Each press this key, the even line will move left with one step (The adjusted value is
increase)
LF/FF:
Each press this key, the even line will move right with one step (The adjusted value is
decrease)
4. Press the
ONLINE
key to select the setting and the printer will print the setting. If the printout result
accords with your request, press
ONLINE
key to enter to the Speed Alignment Adjustment; If the
printout result is not what you want, just adjust it according to step 3.
5. Restart the printer and exit the alignment adjust mode.
Note: Alignment adjust mode will affect the printing quality, think over before adjust it and strict
to the instructions while adjusting.
Figure 4-5 The hexadecimal dump printing
***** HEXADECIMAL DUMP *****
(0000) 1B 34 41 42 43 44 45 46 47 48 49 4A 4B 4C 4D 4E .4ABCDEFGHIJKLMN
(0010) 4F 50 51 52 53 54 55 56 57 58 59 5A 0D 0A 1B 35 OPQRSTUVWXYZ...5
(0020) 41 42 43 44 45 46 47 48 49 4A 4B 4C 4D 4E 4F 50 ABCDEFGHIJKLMNOP
(0030) 51 52 53 54 55 56 57 58 59 0D 0A QRSTUVWXYZ..
