Amsco 36 H, Operator'S Manual

Page: 55 / 152

6-7
Sterilizer Operation Operator Manual P129394-068
6. Following successful completion of the sterilization cycle, unload
the sterilizer as follows:
a. Open chamber door.
b. Remove load from chamber.
c. Slide shelves into chamber, verifying that position does not
interfere with door operation.
d. Close chamber doors.
e. Transfer load to destination.
Figure 6-3. Sterilizer Chamber Equipped with
Rack and Shelves
6.8 Prevacuum
Sterilizer Cycles
AMSCO 400 Series Prevacuum Medium Steam Sterilizers are
shipped with the factory-set cycles. Cycle descriptions are given in
S
ECTION
6.9 , through S
ECTION
6.12 . Refer to Table 1 (page ii) for
factory set, qualified cycle settings.
Important: Applicable cycles have been validated to satisfy the
requirements outlined in Refer to Table 1 (page ii). If cycle
parameters (sterilize time, dry time, temperature) other than those
listed are required, it is the responsibility of the healthcare facility to
consult and follow the device manufacturer’s written instructions.
NOTE: Contact STERIS Corporation for information on a wide range
of education/training programs designed to meet the educational
needs of healthcare industries.
WARNING – BURN HAZARD:
Steam may be released from
the chamber when door is
opened. Step back from the
sterilizer each time the door is
opened to minimize contact
with steam vapor.
WARNING – SLIPPING
HAZARD: To prevent falls
keep floors dry by
immediately wiping up any
spilled liquids or
condensation in sterilizer
loading or unloading area.
!
!
Middle Shelf
Bottom Shelf