Amsco 36 H, Operator'S Manual

Page: 87 / 152

7-9
Cycle and Control Value Programming Operator Manual P129394-068
7.4 Change Time and
Date
Set time and date the sterilizer uses for all display and printout
messages.
NOTE: Change Time and Date feature cannot be locked out under
the Access Code feature.
The current time and date appears on the Off/Standby (screen #0)
and Status (screen #1) screens. Time and date are also shown on
printouts. Verify settings periodically. To change:
1. At screen #1, press MENU touch screen pad. This brings the
MENU screen #2 onto the display.
2. At screen #2, press CHANGE TIME & DATE . The display
advances to screen #31.
3. Make adjustments using procedures shown below:
NOTE: On the control display the selected option is shown as a
black touchpad with white lettering.
• TIME: At screen #31 the TIME touchpad is black. Enter correct
time using keypad.
a. Press the number touchpads to enter hours and minutes. For
example, 10:45 would be entered by pressing
1 0 4 5 0 0 .
(Set display format by referring to S
ECTION
7.5.5, T
IME
F
ORMAT ON PAGE
7-21 .)
b. If an incorrect number is entered, press TIME to start over,
or use the cursor arrows at the bottom of the screen to back
up to an incorrect number.
EXIT
CHANGE
CYCLE
VALUES
CHANGE
MACHINE
SETUP
STATUS . . MENU 2
TEMP . . . 0 F
PRESS . . 0 psig
CHANGE
TIME DUPLICATE
& PRINT
DATE
PAPER SERVICE
FEED MODE