AMSAN AM-FPL9, Manual

Page: 18 / 28

17
Four post parking lift AM-FPL9
(opposite the cylinder rod). Safety latch linkage rod should
pass through guide tubes on underside of runway.
⚫
Install the M12X3200 straight safety latch linkage rod into
the power side runway from the opposite end. The rod should
pass through two guides on the underside of the power side
runway.
⚫
Install the 90 fitting w/O-Ring in the base of power unit pump
next to the lever operated release valve. IT IS NOT NECESSARY
TO USE TEFLON TAPE ON O-RING FITTINGS.
⚫
Connect the 1800MM hose to the fitting on the power unit.
Attach the other end of the 1800MM hose to outside fitting in
power side runway.
⚫
Place a funnel into vent cap hole and fill hydraulic oil in the
power unit reservoir about 10 liters. Recommended Oil: ISO 32,
ISO 46 Hydraulic Oil or Dexron III ATF
⚫
Relocating or changing components may cause problems.
Each component in the system must be compatible; an
undersized or restricted line will cause a drop in pressure. All
valve, pump, and hose connections should be sealed and/or
capped until just before use. All parts should be supplied
from manufacture.
⚫
Air hoses can be used to clean fittings and other
components. However, the air supply must be filtered and dry
to prevent contamination. Most important -cleanliness -
contamination is the most frequent cause of malfunction or
failure of hydraulic equipment.
⚫
Check Pulley Cover and Lock Ladder: Before proceeding,
double check to make sure the locking ladder for the cross-
rail cable pulleys are tight and secure. Check the pulley cover
(2-RIGHT and 2 LEFT) over the shaft located on the pulley side
of each cross-rail. CHECK the pulley and cover are firm
against the locking ladder already in place. Check the
additional lock ladder on the outside of the shaft is tight and
secure. To prevent personal injury or death, cross-rail lock