11
Attention:
Scope of delivery
Introduction
These operating instructions provide important information on the correct installation
and operation of the gas alarm. Please read the instructions completely and carefully
before installation. Keep the instructions and pass them on to third parties as necessary.
Intended use
The GASALARM S/200-P is designed to detect methane, butane and propane gas. It
is intended for use in private homes.
The design is based on a type A device - to emit a visual and acoustic alarm and trigger
an output signal which, in turn, directly or indirectly activates the ventilation or triggers
other auxiliary equipment.
The gas alarm is designed to be connected to a supply voltage of 230 V AC / 50 Hz.
A mains cable attached to the device is used to connect to the mains. In a separate
model, the gas alarm is available for an operating voltage of 12 V DC. The electrical
connection for this model is made via a 2-pole connecting terminal.
The gas alarm must not be used in rooms with potentially explosive atmospheres and
is not a primary measure of protection against explosions in accordance with the
guidelines of the Accident Prevention & Insurance Association.
Devices designed to detect combustible gases are no substitute for correct gas
installation and proper operation of gas plants.
The selection of the location at which measurements are made and the correct
installation of the gas detector are decisive for the proper operation of device. It is
strongly recommended, therefore, that the device is only installed by a qualified
specialist.
1 GASALARM S/200-P
2 fixing screws used for installation
2 fixing plugs
1 Installation and Operating Instructions
