AMS ALF19 Series, Operating Instructions Manual, Page: 43 / 66

Preparing the label feeder for operation 43
ALF19 Series
• The parameter
S1 determines the transport speed after picking up a label.
Increasing this parameter increases the transport speed.

Press the Mode button once.

You are in the start screen

Press the Mode button twice until you see the parameter Speed S1 in the main
menu.

You are in the S1 speed mode . The current setting for S1 is displayed (factory
setting 80 or customer setting).

Press the Up button repeatedly until the value 200 is shown in the display.

The parameter S1 was changed from 80 mm/s to 200 mm/s.
The transport speed increases from 80 mm/s to 200 mm/s.

Press the Mode button three times to return to the start screen to save the
changed value.
Note
• Excessively fast label transport can lead to problems when the labels peel
off. If the adhesion to the label carrier is too strong, the speed must be
reduced. Which label material this is the case for cannot be defined in
advance and must be discovered experimentally. The label feeder's firmware
offers effective options for responding to such difficulties and ensuring a
reliable transport process.
• The parameter
Acc1 determines the acceleration of the label transport up to the
speed set with the parameter S1 .

Press the Mode button once.

You are in the start screen

Press the Mode button for longer than 2 s.

You are in the submenu Parameter ST . The current setting for ST is displayed
(factory setting 10.0 or customer setting).

Press the Mode button once.

You are in the submenu Parameter A1 . The current setting for A1 is displayed
(factory setting 1.0 or customer setting).