The
label feeder at a glance 29
ALF19 Series
Note
• The parameters are transferred to the boards as soon as you exit the menu item
These parameters are only activated by changing from the submenu to the main
menu.
This includes the waiting time of 1 minute, where the control unit then switches to
standby mode, as well as switching the mains voltage off and on.
Resetting parameters to factory settings
Action
Result
Red status LED
Press the Down button and
the
Up button at the same time.
The current parameter is reset
to the factory setting.
-
-
Resetting all parameters to the
factory setting is not possible.
-
Note
• When replacing the label feeder, all parameters must be set again.
Menu
Action
Main menu
Press the Mode button.
Submenu
Press the Mode button for longer than
1s.
Summary of Contents for ALF19 Series
