C-1. Available Accessories and Options
Listed below are the options available for use with
the AMPTEC 620A Series FailSafe Ohmmeters.
Option 620LM-DC: AC Power Adapter Line
Conditioner
Option "620LM-DC" is an AC/DC Wall adapter that
safely converts and conditions 115VAC line voltage
to 24VDC at 300mA. One adapter is provided as a
standard accessory with every 620LM . It is fitted
with the mating Molex connector that is specifically
compatible with the meters rear panel molex
connector. Additional Isolation electronics is insode
the AMPTEC 620LM but this particular AC power
adapter has been shown to continuously provide
isolated DC power (to 3 KV AC and 3 KV DC) for
the AMPTEC 620LM Igniter Tester.
Option 100: Carrying Case
Option "100" is a hardshell (impact resistant plastic)
shock absorbing foam lined meter and accessory
carrying case for the 620A Ohmmeter with extra
room for test leads, battery charger, Kelvin Clip Test
Leads, Connector Adapters, single pointed probes
and operator manual etc.
Option RACK: Rack Mount Adapter
Option "620RACK" includes an adapter tray that
allows any AMPTEC 620 series tester to be flush
panel mount installed in a standard 19" NEMA
equipment rack.
Option “500” Optically Isolated Analog
Output
New Options and Custom Leads Available
Contact the sales department at AMPTEC
RESEARCH (phone 1-800-350-5105) if you
have need for a special probe, adapter, lead set,
or custom option not listed in this manual.
AMPTEC’S experienced application engineers
have helped supply many customers with special
igniter tester accessory requirements.
This rear panel mounted isolated analog DC
Voltage output signal is directly proportional to
the 620 tester's ohm display measurement. (i.e.
1.2345 VDC for 12.345 ohms). It is used to track
620 tester measurements for datalogging pur-
poses with an external device (i.e chart recorder,
system DMM with GPIB). Isolation protection is
rated @2000 volts peak to insure any instrument
connected to "Option 500" has virtually no
impact on the 620 series tester's safety.
SECTION C OPTIONAL ITEMS AND
ACCESSORIES
