Ampro LittleBoard 800, Reference Manual

Page: 18 / 96

Chapter 2 Product Overview
12 Reference Manual LittleBoard 800
Connector Definitions
Table 2-2 describes the connectors shown in Figure 2-6. All I/O connectors use 0.100” pin (2.54mm)
spacing unless otherwise indicated.
Table 2-2. Connector Descriptions
Jack # Name Description
BT1 Battery Socket Battery socket for 3.2 volt Lithium battery
DIMM1 Memory 184-pin, 1.27mm, slot for a single DDR RAM DIMM
J1A,B,C,D PC/104 bus 104-pins for PC/104 connector
J2A,B,C,D PC/104-Plus 120-pin, 2mm, connector for PCI bus
J3 Video (CRT) 10-pin connector for output to a CRT type monitor
J6 Primary IDE 40-pin connector for the primary IDE interface
J7 Secondary IDE 40-pin connector for the secondary IDE interface
J8 CompactFlash 50-pin, 1.27mm, socket accepts Type 1 or Type II CompactFlash cards
J9 Audio In/Out 26-pin, 2mm, connector for all of the Audio signals (input/output)
J10 Ethernet 2 8-pin RJ45 connector for 10/100/1000BaseT Ethernet port
J11 Serial A 20-pin connector for serial ports 1 and 2 (COM 1 & COM 2)
J12 Serial B 20-pin connector for serial ports 3 and 4 (COM 3 & COM 4)
J13 Utility 2 24-pin connector for mouse, IrDA, SMBus, USB 0 & 1,
power button
J14 Utility 3 10-pin connector for USB2 and USB3 ports (bi-direction)
J15 Utility 1 16-pin connector for keyboard, external battery, reset switch, speaker
J16 Parallel 26-pin connector for parallel port
J17 Floppy 34-pin connector for floppy disk drive interface
J19 Power In 7-pin, 0.156" (3.96mm), connector for input power
J21 Optional Fan 3-pin header pr5V, tach, and ground to optional CPU fan
J23 Ethernet 1 8-pin RJ45 connector for 10/100BaseT Ethernet port
J26 Video (LVDS) 30-pin, 2mm, connector for LVDS type video displays
NOTE
Ampro uses a connector/header identification method in Chapter 3 to
avoid difficult to see visible numbering next to the connectors. For
example, a 20-pin header with two rows of pins, using odd/even
numbering, where pin-2 is directly across and adjacent to pin-1, is noted
in this way; 20-pin, two rows, odd/even (1, 2). Alternately, a 20-pin
connector using consecutive numbering, where pin-11 is directly across
and adjacent to pin-1, is noted in this way; 20-pin, two rows, consecutive
(1, 11). The second number in the parenthesis is always directly across
from and adjacent to pin-1, with a few exceptions (DIMM1 slot,
PC/104-Plus, PC/104). See Figure 2-5.
20-pin, two rows,
Consecutive, (1, 11)
Or
1
2
3
4
5
6
7
8
9
10 20
19
1 2 4
15
11
20
10 5 3
20-pin, two rows,
Odd/Even, (1, 2)
L
B
800
_Co
n
N
u
m
Figure 2-5. Connector Pin-Out Identification