Amphenol Kaye CTR-40, User Manual, Page: 53 / 84

42
8 Controller Operation
Pt=5
Pf=4
Use the “UP” or “DOWN” buttons to change the time.
New soak time
Press “SET” to continue.
S
Save new setting
8.6.4 Program Function Mode
The next parameter is the program function or cycle mode. There are four pos-
sible modes which determine whether the program scans up (from set-point 1
to n) only or both up and down (from set-point n to 1), and also whether the
program stops after one cycle or repeats the cycle indefinitely. Table 3 below
shows the action of each of the four program mode settings.
1 up-stop
2 up-down-stop
3 up-repeat
4 up-down-repeat
Program mode
Use the “UP” or “DOWN” buttons to change the mode.
New mode
Press “SET” to continue.
S
Enter program menu
8.6.5 Program Control
The final parameter in the program menu is the control parameter. Three op-
tions are available for controlling the ramp and soak program. The options are
to start the program from the beginning, (
GO
), continue the program from
where it was when it was stopped (
Cont
), or stop the program (
OFF
).
Program presently off
Use the “UP” or “DOWN” buttons to change the status.
Pf=1
Pr=OFF