Amity Technology 2720, Operating Manual

Page: 80 / 95

13 - 11
- Joystick Position: The joystick position is the current position of the joystick. This will display
“ CENTER, ” “ NORTH, ” “ EAST, ” “ SOUTH, ” and “ WEST ” based upon which position the joystick is in.
“ Center ” is the natural position of the joystick (vertical). “ North ” is shown as an arrow on the physical
joystick.
- Auto Axle: Auto axle displays “ ENABLED ” or “ DISABLED ” based on if the END RAISE function is tog-
gled on or off.
- Software Version: The software version is the current software version loaded onto the ECU.
- VT Info: VT Info displays info about the physical screen ’ s hardware and software for troubleshooting
and informational purposes.
13.1.6 Settings Page
Figure 13 - 25 shows the Settings Page, which displays
settings and allows for changes to some settings for the
system which are as follows:
- Joystick Configuration: The joystick has four different
layout options. The joystick can perform four different
functions by pushing it North, East, South, or West.
North is designated by an arrow on the physical joystick
and is considered the top function on this screen. To se-
lect a configuration, press one of the options shown on
the screen. The configuration will be outlined in green
once selected to show which option is currently being
used. The possible functions that the joystick can per-
form are as follows:
1. “ AUTO ”: Toggles in and out of “ AUTO ” mode.
2. “ END ROW ”: Enters the system into “ End Row ” mode
3. “+”: Increase the target depth of the harvester. Increases the depth in increments of 0.2 inches.
4. “ - ”: Decreases the target depth of the harvester. Decreases the depth in increments of 0.2 inches.
5. “ LOWER ”: Lowers the front of the harvester using the hitch cylinders. The front will be incremen-
tally lower with each movement of the joystick. The increment size is PTO dependent. See part F in
section 13.1.4, for details. With the PTO running the movement will be small, and with the PTO not
running the movement will be greater. Using the
“ LOWER ” or “ RAISE ” function will cause the system
to exit out of “ AUTO ” mode. It will raise or lower the machine and enter into manual mode.
6. “ RAISE ”: Raises the front of the harvester using the hitch cylinder. The front will be incrementally
raised with each movement of the joystick. The increment size is PTO dependent. See 13.1.4, “ F ” for
details. With the PTO running the movement will be small and with the PTO not running the move-
ment will be greater.
Figure 13 - 25: Settings Page