Amit IWP87DAM-07151, User Manual

Page: 30 / 320

PoE AP Router
30
2. Unchecked by default uplink.
If
you activate the function, further Signal threshold value has to be
specified. The default value is 40%
Value Range : 30 ~ 60 %.
Network Monitoring
1. An optional setting
2. Enabled by default.
When the Network Monitoring feature is enabled, the gateway will use
DNS Query or ICMP to periodically check Internet connection –connected
or disconnected.

Choose either DNS Query or ICMP Checking to detect WAN link.
With DNS Query, the system checks the connection by sending DNS
Query packets to the destination specified in Target 1 and Target 2.
With ICMP Checking, the system will check connection by sending
ICMP request packets to the destination specified in Target 1 and
Target 2.

Loading Check
Enable Loading Check allows the router to ignore unreturned DNS
Queries or ICMP requests when WAN bandwidth is fully occupied.
This is to prevent false link ‐ down status.

Check Interval defines the transmitting interval between two DNS
Query or ICMP checking packets.

Check Timeout defines the timeout of each DNS query/ICMP.

Latency Threshold defines the tolerance threshold of responding
time.

Fail Threshold specifies the detected disconnection before the router
recognize the WAN link down status. Enter a number of detecting
disconnection times to be the threshold before disconnection is
acknowledged.

Target1 ( DNS1 set by default ) specifies the first target of sending DNS
query/ICMP request.

DNS1 : set the primary DNS to be the target.

DNS2 : set the secondary DNS to be the target.

Gateway : set the Current gateway to be the target.

Other Host : enter an IP address to be the target.

Target2 ( None set by default ) specifies the second target of sending
DNS query/ICMP request.

None : to disable Target2.

DNS1 : set the primary DNS to be the target.

DNS2 : set the secondary DNS to be the target.

Gateway : set the Current gateway to be the target.

Other Host : enter an IP address to be the target.
Save N/A Click Save to save the settings.
Undo N/A Click Undo to cancel the settings.