AMIMON Connex LR, Manual

Page: 24 / 56

• The OSD button on the Ground Unit is set to enable the display of flight control (Telemetry) informa-
tion.
When the Air Unit receives valid Telemetry messages from the drone flight controller, these messages
are transmitted to the Ground Unit, which displays the additional Telemetry information on the OSD.
This may require a few seconds to take effect.
For a list of supported remote controls and gimbals, see Supported Remote Controls, Gimbals and
Telemetry Flight Controllers [13] .
To display OSD information:
• While all LEDs on the Ground Unit are lit, press the OSD button on the Ground Unit. The following is
an example of the OSD View:
Figure 6. OSD View - With Additional Telemetry Information
Alert and System Messages
The tables below describe messages that may appear on the monitor connected to the CONNEX LR
HDMI port.
Alert Messages – Overlaid on Video During Link
These alert messages may be displayed on top of the live video:
Alert Description
Video Signal Not De-
tected A link has been established between the Air Unit and the Ground Unit, but no video signal has been
detected. This message is displayed regardless of the OSD button position.
System Messages – No Link
These system messages may be displayed when no live video is displayed:
Alert Description
Searching for Air
Unit This message is displayed until a link is established. This may occur when the Air Unit is out of range or
unavailable, or when the Ground Unit has been removed from its list of paired devices.
Pairing in Progress This message is displayed while the Air Unit is pairing with a Ground Unit.
For a detailed description of the pairing process, see Multicasting to Multiple Ground Units [25] .
Connex LR Manual
24