AMIMON Connex LR, Manual

Page: 17 / 56

Figure 2. S.BUS/PWM/PPM Port Cable
3. The default gimbal command transmission bit rate is FASSTest 12CH Mode (6.3m sec). If this bit
rate is not supported by the gimbal controller, use the CONNEX Management application to config-
ure the S.BUS Bit Rate manually (see
Checking the Ground Units Registered to an Air Unit (Win-
dows / MAC) [35] and Configuring Fail Safe Parameters (Android) [53] ).
The CONNEX LR automatically detects the S.BUS/PWM/PPM and transmits the gimbal commands
over the wireless return channel to the Air Unit’s S.BUS/CTRL port.
For a list of supported remote controls and gimbals, see Supported Remote Controls, Gimbals and
Telemetry Flight Controllers [13] .
Connex LR Manual
17