60
IV. MAKE THE ESPRESSO (Fig. 4).
OPERATION
1. Make sure that the drip tray is under the coffee spout and water tank is installed and then press the
power on / off button to turn on the appliance. The appliance will automatically purge the system with a
small cup of water. Press the
button to stop this.
2. The appliance is then on standby.
3. Place a cup under the coffee spout and adjust the height of the spout to fit your cup. Depending on
the size of the cup (too tall or too wide), you can remove the drip tray or adjust its position as follows:
4. The selected Espresso button
will light up and the backlight will indicate that the appliance is
brewing a cup of coffee.
5. When the appliance enters a standby mode, the coffee is ready to be served.
Note: Automatic rinsing will not take place if the appliance is turned off and on again. You can
disable or enable this feature by following the steps below.
Step 1) Remove the service lid
Step 2) Press the on / off button until you hear a beep.
Note! Press the hot water button to rinse the inside of the coffee maker before first use.
4