Instruction Manual |
21
fig. 8
Reversing the door
You will need the help of another
person, during this process, to lean
the wine cooler back and support
it.
1. Remove the rear ventilation trim
(3) by removing screws (1) from
both sides and sliding the trim out
from below. Then remove the front
ventilation trim (2) by removing
screws (4) from each side as
shown in fig. 8. These screws (4)
are located above and behind the
front ventilation trim (2) and their
location is indicated by the dotted
line in fig. 8.
2. Remove the remaining plinth trim
supports (Fig. 11) by removing
the screws marked S1 through
the holes marked H1 and the
screws marked S2 through
the gaps marked as H2.
fig. 9
fig. 10
S1
H1
H1
S1
S2
S2
H2
H2
fig. 11
3. Remove the lower hinge (5) by removing the four screws (6) as
shown in fig. 9. Support the door as you do to prevent damage.