Amiad Water Systems | 2019
TEQUATIC™ PLUS F-150 Filter, C-series Skid
10
Installation
2.2 Site Preparation
Before the physical installation of the
system, it is important to make sure the
installation area is properly configured for
accessing the system. The allotted space
should include the physical requirements
of the equipment plus additional space for
working and maintenance clearance.
At a minimum, the area in front of the
control panel should be left open to permit
the operator access for daily operation.
Additional space may be required for local
codes.
Maintenance clearance around the system
is more subjective and may vary depending
on the frequency of maintenance tasks.
When planning the space, consider having
extra clearance near the pump to facilitate
removal or servicing.
2.3 Unpacking the Skid
Notice
: Be careful when working around the filter housing with tools to avoid damaging the housing. Also,
take care not to disturb the pressure and speed sensors on the upper filter housing.
Note:
Shipping damage must be noted at the time of receipt, and claims made to the freight company.
•
Remove all packing materials from the skid and inspect the system for shipping damage.
•
Inspect all of the plumbing lines and fittings to ensure they are firmly tightened and undamaged.
•
Inspect the controller cabinet to ensure that all components are firmly in place and no wires have
loosened.
•
If the system was shipped on a pallet, remove any strapping and lag bolts, and lift the system off the
pallet using the lifting points shown in the following section.
7'-6"
11'-0"
