amiad ICS-TCP Series, Installation, Operation And Maintenance Instructions

Page: 30 / 34

Page 9
Rev: 091014 Operating and Maintenance
Manual
P
a
g
e
9
4. Operation
4.1 Initial Operation
•
Always use the appropriate PPE when working with electrical components.
•
With the electrical source isolated, connect the appropriate electrical connections to the Amiad
Controller. Check on the data plate to ensure the appropriate power supply is connected.
•
Add necessary short circuit protection as required on schematic.
•
Ensure pump is appropriately supplied with water
•
Ensure Stop connections are installed.
•
Check the motor data plate and ensure that the motor overloads are set to the FLA on the data
plate.
•
Check to make sure that Circuit breakers within panel are switched to the off position.
•
Before switching power on to the panel, use a meter to ensure the correct voltage is being
applied to the panel.
•
Switch power on the panel.
•
Check for leaks within the pipes and tighten if necessary.
•
Before switching circuit breakers on check voltages on the secondary of the transformer to
ensure the correct voltage.
•
Apply power to the control circuit by switching on the circuit breakers.
•
Check configuration of Inputs and Outputs if applicable
•
Check timers to ensure appropriate flush parameters.
4.2 Deactivation
•
Turn disconnect to the off position.
•
Turn all Circuit breakers to the off position.
•
Apply appropriate lockout/tag out measures to ensure that nobody accidentally switches power
on.
30 of 34