amiad ICS-TCP Series, Installation, Operation And Maintenance Instructions

Page: 27 / 34

Page 6
Rev: 091014 Operating and Maintenance
Manual
P
a
g
e
6
3. Product Description
It enables users to have a powerful filter controls in a compact design. It is available in a wide array
power classes and voltages to meet the needs of the world market. The filter system is driven typically
by the differential pressure of the inlet and outlet, but can also use a pushbutton, remote start, or other
start signals.
The system is designed specifically for each customer’s needs. Refer to drawings/schematics or
electrical data plate on the side of the enclosure to determine largest motor to be used and specific
technical data.
3.1 Functional Description
Utilizing a start command for the flush cycle, the system is designed to be self-sufficient. There is no
need to interfere with the filter as the process uses the highest level of technology to control the filter
assembly/assemblies. Typical start command is given by a differential pressure switch, however has
available onboard inputs for a variety of different applications. Consult your local Technical Sales
Engineer for more details on how to integrate the controller and maximize efficiency.
3.2 Standard Component Description
The following is for the standard configuration and added controls may enhance the capabilities of your
controller.
Disconnect Switch
This disconnect switch is for power isolation. It’s capable of handling up to 600VAC, CE marked, UL
approved, and conforms to most international standards.
Contactor and Overloads
The contactor and overload allows the end-user to have full control over the pump/drive motor. From
the factory, the pump/drive motor is controlled to either shut on or off with the flush, but is easily
modified to accept different logic schemes. The overloads use solid-state technology to determine if the
motor is being overdriven. At the factory these settings are applied and checked before leaving. Raising
the overloads current value over the factory settings or removing the overloads from the controls will
inhibit the ability of the controller to properly protect the motor. This setting should not be modified
without contacting the factory first. It is CE-marked, UL approved, and conforms to most international
standards.
27 of 34