COPYRIGHT © 2011 AMI ENTERTAINMENT NETWORK, INC.
MEGATOUCH ION RX OWNER’S MANUAL PM0721-09
5
Rx Optional Marquee Installation Instructions
CAUTION
WHILE THE RX MARQUEE IS OPTIONAL, DUE TO THE STRONG ADHESIVE USED TO
SECURE IT, ONCE IT IS INSTALLED, IT IS NOT MEANT TO BE REMOVED.
The marquee should never be used as a handle when servicing the game, as it was not
designed for this purpose. When used inappropriately in this fashion, the marquee
could break, causing the bezel to slam down and thereby damaging the system.
The monitor bezel should always be opened by using the handle on the rear of the
coin/bill acceptor.
Before you begin installation:
Line up the marquee as shown in Figure A. The right side of the marquee (looking from
the front) should be even with the front of the plastic on the coin/bill acceptor, and the
front base of the marquee should be even across the front of the monitor bezel. This step
is just so you can see how the marquee should fit without using any adhesive. You may
also find it helpful to use a pencil and draw and very light line on the top of the bezel to
mark the rear of the marquee. You can then follow this guideline when you permanently
secure the marquee to the bezel.
COIN/BILL
ACCEPTOR
MONITOR
Marquee Installation:
1.
Remove the two strips covering the two pieces of tape on the bottom of the
marquee.
2. Carefully line up the marquee on top of the bezel. Follow any guidelines you have
drawn for yourself, or refer to Figure 1 for placement.
3. Press down on the base of the marquee to ensure that the adhesive has fully bonded
with the bezel.
FIGURE A - RX MARQUEE PLACEMENT (SIDE VIEW)
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +1.561.391.7200