AMGO A245LX, Installation And Service Manual

Page: 31 / 39

29
Please read the safety tips carefully before operating the lift
To lift vehicle
1. Keep clean of site near the lift;
2. Position lift arms to the lowest position;
3. To shortest lift arms;
4. Open lift arms;
5. Position vehicle between columns;
6. Move arms to the vehicle’s lifting point;
Note: The four lift arms must at the same time contact the vehicle’s lifting point
where manufacturers recommended
7. Turn on the power switch (QS1), press the “ UP” button until the lift pads contact
underside of vehicle totally. Recheck to make sure vehicle is secure;
8. Continue to raise the lift slowly to the desired working height, ensuring the balance
of vehicle;
9. Push button “ DOWN” , lower lift onto the safety position. The vehicle is ready to
repair.
To lower vehicle
1. Be sure clear of around and under the lift, only leaving operator in lift area;
2. Push the button “
UP” to raise the vehicle slightly, and then release the safety device,
push button “DOWN” to lower lift.
3. Open the arms and position them to the shortest length;
4. Drive away the vehicle.
5. Turn off the power.
VII.MAINTENANCE SCHEDULE
Monthly:
1. Re-torque the anchor bolts to 150 Nm;
2. Check all connectors, bolts and pins to insure proper mounting;
3. Lubricate cable with lubricant;
4. Make a visual inspection of all hydraulic hoses/lines for possible wear or leakage;
5. Check Safety device and make sure proper condition;
6. Lubricate all rollers and pins with 90wt. Gear oil or equivalent;
Note: All anchor bolts should take full torque. If any of the bolts does not function for
any reason, DO NOT use the lift until the bolt has been replaced.
Every six months: