S-4000 BH Omron
1-26
Released 05/2010
e-mail: [email protected]; [email protected]; website: www.amfreece.com
Phone: +420 582 309 286; Fax: +420 582 360 606
D - MACHINE CONTROLS
7.
Em stop
Clamp button
On
Off
-
During presing the clamp feet button
this appears on the display:
and clamp feet
Em stop
Clamp button
On
On
are closed. By next pressing the
button clamp feet are opened. Switch SB3 is tested by this parameter.
8.
Motor ready
On
-
If
Motor Ready
Off
appears on the display, go to the
„Troubleshooting“ section.
9.
BH sensor
On
-
BH bartack sensor check. After getting to the position outside of the
bartack
BH sensor
Off
appears. Sensor BQ4 is tested by this
parameter.
OUTPUTS TESTS
One can test the following parameters only if the air is supplied to the machine. By pressing the button
on the last Inputs tests screen.
Output tests
Off
Clamps
appears on the display. By pressing the
button
you can set the row intended to change. The changed output is signalized by flashing. By pressing
button you get the next screen. You can return to the prewious screen using
F2
button. By pressing
button you return to the main screen.
10.
Output tests
Clamps
Off
-
For activation of clamp the feet press
➡
Output tests
Clamps
On
, confirm by
➡
Output tests
Clamps
On
and clamp feet are closed. For releasing the clamp feet press again
➡
Off
Output tests
Clamps
, confirm by
➡
Output tests
Off
Clamps
and clamp feet are opened. Valve YV2 is tested
by this parameter.
11.
Knife
Trim
Off
Off
-
For activation of the cutting lever and tension press
➡
Display
Summary of Contents for S-4000 BH Omron
Page 4: ......