S-4000 LT
1-29
Revised 10/2004
e-mail: [email protected]; [email protected]; website: www.amfreece.com
Phone: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
6 . F E E D I N G
1.
Tilt the sewing head on the rest pin.
2.
Bevel Gear Adjustment
Manually turn the hand wheel counter clockwise, until the
drive spring in the main cam engages with a detent (first
row of stitches). Remove the bevel gear cover and loosen
the screws
➊
,
➋
on the horizontal bevel gears and screw
➌
on the stop.
3.
Loosen two adjusting screws
➍
in the right collar
➎
.
Adjust the dimension 11mm from the end of the feed shaft
➏
to the collar
➐
by pressing the feed shaft
➏
against the right
collar
➎
. Tighten the adjusting screws
➍
in the right collar
➎
. The tension of the left collar on the shaft is set.
4.
Engage the left bevel gear
➑
with the vertical bevel gear
➒
and lock its position by set screws
➋
. Move the stop against
the gear and tighten set screw
➌
.
5.
Manually turn the hand wheel counter clockwise until the
feed shifter lever moves to its full left position then slide the
right gear
➓
into engagement with the vertical gear
➒
.
Tighten set screws
➊
securely.
The bevel gear adjustment is done. By manually turning the
handwheel finish the sewing cycle and bring the machine to the
home position. Reinstall the bevel gear cover.
6.
Clamp plate movement occurs only when the needlepoint
has risen above the work piece and must be completed
before the needle descends into the work.
7.
For adjustment use a piece of paper to see the needle
punctures.
If feeding occurs while the needle is in the work, engage
the drive spring into a detent.
Loosen the screws
on the feed cam and adjust its
position as needed so that all feed motion occurs with the
needle out of the work. Retighten the feed cam set screws.
11 MM
E - MACHINE ADJUSTMENTS