S-4000 LT
1-15
Revised 10/2004
e-mail: [email protected]; [email protected]; website: www.amfreece.com
Phone: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
Ì
Í
A
B
C
D
Ê
Ë
Î
1. PROGRESS FOR SEWING A BUTTONHOLE
1.
Put the machine to the home position according to
the section C1.
2 .
Make sure, that is threaded correctly according to
section
C3,
and insert the sewn work under the
clamp feet. Proper work location will be easier with
front stop
➊
which is adjustable.
3 .
When the foot pedal
➋
is pressed to the first
position,the sewn work is clamped by the head
clamp feet, suction of the overhanged material
➌
and cutting. (Releasing the foot treadle will raise
the clamp feet).
N o t e :
It is possible to set in the program the start
of the machine on the first position.
4 .
When the foot pedal is pressed (in the second
position), the decorative buttonhole sewing begins.
After the buttonhole is sewn and the thread is
trimmed the machine goes back to the home
position.The clamps are up and rest of the thread
on the needle is placed with the air current above
the needle protector..
5 .
After the clamps are up, it is possible to move the
sewn work for sewing another buttonhole.
6 .
Machine can be stopped in any place of the cycle
by pressing the Emergency Stop button
➍
which is
placed on the machine head. After releasing the
Emergency Stop button, pressing
button and
pressing the foot pedal, the machine finishes the
buttonhole.
7.
When the foot pedal
➌
is pressed before the
buttonhole is finished, the clamp feet will not raise
and the machine will again sew the buttonhole — it
is possible to set it in the program buttonhole, the
clamp feet will not raise and the machine will again
sew the buttonhole - possible to
set in program.
8 .
When the work is finished, switch the machine off
rotaring the switch
➎
to the position
O
.
D - MACHINE CONTROLS