Revised 12/2007
E-mail: [email protected]; [email protected]; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
S-105
1-42
D - MACHINE ADJUSTMENT
14.5 Adjustment of safety latch – turn the left wheel. Once the machine is in the home position and feet levers
release, the safety latch should be above the groove placed on the tip of the square . To make adjustment,
loosen screws and move the support upwards or downwards as necessary so that the latch drops
into the groove. Once the adjustment is done, tighten the screws . The minimal play required between
the lever and the tip of the clamping arm is 0,8 mm. To adjust it, loosen the screw and turn the eccentric
nut as needed . Tighten the screws after the adjustment.
14.6 Selection of cut before (CB) or cut after (CA)
Changing CB for CA
1. Change the machine over from the home position (half of the sewing cycle).
2. Move the lever that is placed on the left side in the rear part of the machine head into the
CA
position.
3. Loosen the screw and move the guiding travel backwards, to the
CA
position. Once the guiding
travel is moved backwards, tighten the screw .
Changing CA for CB
1. Change the machine over from the home position (half of the sewing cycle).
2. Move the lever that is placed on the left side in the rear part of the machine head into the
CB
position
.
3. Loosen the screw and move the guiding travel forward, to the
CB
position. Once the guiding travel
is moved forward, tighten the screw .
0
,8
m
m