AMF REECE S-105, Parts And Service Manual, Page: 37 / 68

Revised 12/2007
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
S-105
1-25
Lift up the machine head into vertical position over the cam case, turn the left hand wheel and check that
the pistons go into the guiding travel
Î Î Î Î Î freely. If not, loosen the screw Ð Ð Ð Ð Ð of the lever Ñ Ñ Ñ Ñ Ñ and adjust the
table position with the cam
Ï Ï Ï Ï Ï
, tighten the screw
Ð Ð Ð Ð Ð
again as needed.
D - MACHINE ADJUSTMENT
1 . TA B L E A D J U S T M E N T
WARNING: At the manufacturer, the stud holder Í Í Í Í Í is fitted with small wedges and fixed with a pin. Do
not change the position of wedges. Switching over the stud can be adjusted after turning the cam into the
position when the roll
Ë Ë
Ë Ë Ë
is in the position Ò Ò
Ò Ò Ò
of cam travel Ì Ì
Ì Ì Ì
. The stud Í Í
Í Í Í
should leave the groove Î Î
Î Î Î
in
the cam at this point. If not, adjust the Ó Ó
Ó Ó
Ó bracket as needed once you loosen the screw .
Í
Ó
Ñ Ê Ð
Ë
Ì
Ò
Î Ï