AMF REECE S-105, Parts And Service Manual, Page: 21 / 68

Revised 12/2007
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
S-105
1-9
8
7
0
m
m
2 . TA B L E I N S TA L L AT I O N
2.1. Once you unpack the machine, install it onto its intended place. The machine is supplied with a table
of a standard high to work on it while seated. If you require a different table, discuss it with the
machine manufacturer. The recommended height of the table is 870 mm measured from the floor.
The height can be adjusted by lifting up the desk once you loose the screws
Î Î Î Î Î
. Tighten the screws
firmly after the adjustment.
2.2. The stability is secured with the rear support
Ë
, that is operated with a hand screw
Ì
. Check the
desk level.
2.3. Remove the secure belt
Í
preventing the machine head to tip out from the frame. When transporting
the machine, fasten the table so that it does not move.
1 . C O N T E N T O F C O N S I G N M E N T
1.1. If not stated otherwise, the consignment contains the following:
- machine with electro installations already built onto the stand
- cardboard with accessories
(specification in the Spare Parts section)
- thread stand dismantled
Ê
- operator’s manual with Spare parts list
1.2. When unpacking the machine, it is necessary to follow marks
placed on the wrapping.
WARNING: Visible damaged of the consignment that happened during the shipment must be immediately
reported to the carrier. Check the content of the consignment with the order. Possible impediments must
be immediately reported to the manufacturer. Later claims cannot be acknowledged!
Ê Ê
Ê Ê
Ê
B - MACHINE INSTALLATION
Í
Ì
Ë
Î