AMF REECE S-105, Parts And Service Manual, Page: 53 / 68

Revised 12/2007
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
S-105
1-41
D - MACHINE ADJUSTMENT
14.1 The basic position of the clamp plates with clamp feet can be adjusted by turning the left hand wheel. The
rolls Ê Ê
Ê Ê Ê
on the knife holder wedge spreader and the clamp plates are spread. Loosing the screws Ë Ë
Ë Ë Ë
make
sit possible to adjust the stoppers Ì Ì
Ì Ì
Ì . The gap X should be same on both plates (asi 0,8 mm). Alignment of
plates is adjusted by the stud Í Í Í Í Í . Once it is loosen, check that the distance V is the same for both clamp
plates from the knife cut.
1 4 . A D J U S T M E N T O F C L A M P I N G M E C H A N I S M
14.2 In order to prevent the needle hitting the clamp foot, it is possible to adjust the position of the foot by
loosing the screws Î Î
Î Î
Î vertically onto the sewn buttonhole (the recommended gap between the foot and a
row of stitches is 0,8 mm) and in longitudinal axis once you loose the screws Ï Ï Ï Ï Ï
.
14.3 With its design, the clamping mechanism enables clamping material of different thickness. Clamp a piece
of material manually with a lever Ð Ð Ð Ð Ð to adjust the pressure. Use the hand wheel on the left side and turn the
main cam so that the ramp Ñ Ñ
Ñ Ñ Ñ
lowers down the whole operating mechanism as much as possible. Loosen
the stud nut Ó Ó
Ó Ó
Ó to adjust its position with the screw , once you loosen the nut so that the lever leans
against the bottom square surface . Test the function.
14.4 Loosen the nut and adjust the height of the feet above the plates Ò Ò
Ò Ò
Ò 10 mm can be adjusted with a screw .
NOTE: It is suitable to check the function of the mechanism to adjust levers for both, cut after (CA) and cut
before (CB) seaming.
0,8 mm
1,5 - 2,0 mm
Î Î Î Î Î Ò Ò Ò Ò Ò
Ê Ê
Ê Ê Ê
Ñ Ñ
Ñ Ñ Ñ
Ð Ð
Ð Ð Ð
Ó Ó Ó Ó Ó
2 mm 4 mm
Í Í
Í Í Í
Ï Ï
Ï Ï
Ï
Ì Ì
Ì Ì Ì
Ë Ë Ë Ë Ë